Search results
Results from the WOW.Com Content Network
Gear inches is one way of measuring the gear ratio(s) of a bicycle, so that different gears and different bicycles can be compared in a consistent manner. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.
A crossed helical gear is a gear that operate on non-intersecting, non-parallel axes. The term crossed helical gears has superseded the term spiral gears. There is theoretically point contact between the teeth at any instant. They have teeth of the same or different helix angles, of the same or opposite hand.
The Oshkosh M-ATV is a mine-resistant ambush protected vehicle developed by the Oshkosh Corporation for the MRAP All Terrain Vehicle (M-ATV) program. Intended to replace M1114 HMMWVs (Humvee), it is designed to provide the same levels of protection as the larger and heavier previous MRAPs, but with improved mobility.
The ATC200X, released in 1983, was Honda's first 4-stroke Sport model. The machine was based on the ATC200 line, but was virtually unique in its set-up and engine tuning. . It featured a 5-speed transmission with manual clutch and full suspension with 7.3” of front travel and 6.7” of rear trav
The Tiger 500 is notable for being the fastest consumer ATC available, with tested top speeds of +80 mph from the stock 42 horsepower (31.3 kW)@6500rpm engine and 5 speed gearbox. With final drive gearing changes, the ATC could exceed 100 mph.
The bicycle's short gearing assisted when cycling uphill, but the CVT was noted to significantly increase the weight of the bicycle. [52] The rise of the electric bicycle has brought a reappraisal of the CVT as a better solution for an optimal drive train set up in comparison to gearing systems historically applied on human powered bicycles.
The 450R was first across the line in the ATV class with a total time of 22 hours, 27 minutes, and 24 seconds. ... Length 72.6 in 73.3 in Width 46.3 in Height 43.6 in ...
Meshing of two spur gears with involute external teeth. z 1 = 20, z 2 = 50, α = 20°, x 1 = x 2 = 0, ISO 53:1998. The lower (green) gear is the driving one. The line of contact, which is the locus of all teeth contact points, is shown in blue.