Search results
Results from the WOW.Com Content Network
Regulatory definition: For the purpose of U.S. regulation and GTRs (Global Technical Regulations)—and for clear communication in safety and seating design [7] —the H-point is defined as the actual hip point of the seated crash test dummy itself, [7] whereas the R-point (or SgRP, seating reference point) is the theoretical hip point used by ...
A 2+2 (also 2-plus-2) is a car-body style that has a seat each for the driver and front passenger, and two rear seats. The latter may be individual "bucket" seats, fold-downs, or a full-width "bucketed" bench seat, but always with less leg room than either the front or a standard 2-door car. [1] [better source needed] The style is different ...
In motorsport, the racing setup, car setup or vehicle setup is the set of adjustments made to the vehicle in order to optimize its behaviour (performance, handling, reliability, etc.) for specific conditions. Vehicle setups are variable for a variety of reasons, ranging from weather, driver/rider preference and race track characteristics.
The configuration of a car body is typically determined by the layout of the engine, passenger and luggage compartments, which can be shared or separately articulated. A key design feature is the car's roof-supporting pillars , designated from front to rear of the car as A-pillar, B-pillar, C-pillar and D-pillar.
The handling of the car was then tested. It climbed a set of hills with blind turns while increasing its speed by 10% each time. At the top, the car almost crashes into an oncoming semi-truck before swerving out of the way. The car was now brought to the final test shown in the briefing room: the barrier test. The car lined up across from a ...
The power seat adjustments in a Lincoln Town Car. The seat controls are located on the door panels, next to the memory seat controls. Above the seat settings are the memory control settings that also set the mirrors and foot pedals. Some car seat systems are set up with a battery-powered automatic control to adjust how the seat sits in the car.
The metric 200 three-speed automatic transmission became standard on all models and a new Chevrolet-built 229 cu in (3.8 L) V6 with 2-barrel Rochester carburetor replaced both the 200 cu in (3.3 L) V6 of 1979 and the Buick engine offered on all 1978 models and the 1979 Landau as the standard engine in 49 states (California cars continued to use ...
A car buyer may add to this standard equipment with trim packages or individual options. The trim level with the least equipment/features is referred to as the "base model," [ 2 ] and the trim level with the most equipment/features is referred to as "highest specification" or colloquially as "fully loaded."