Search results
Results from the WOW.Com Content Network
That cable would then run from the roof into the house. At a convenient point, a second diplexer would split the two signals apart; one signal would go to the TV set and the other to the IRD of the DBS set-top box. These usually have an antenna input and a diplexer, so that the antenna signal is also distributed along with the satellite.
A dual-polarized signal thus carries two independent data streams to a receiving antenna, which can itself be a single-polarized one, for receiving only one of the two streams at a time, or a dual-polarized model, again relaying its received signal to two single-polarization output connectors (via an OMT if in waveguide).
Parking assist systems: when the driver engages reverse gear, the transmission control unit can send a signal via the CAN bus to activate both the parking sensor system and the door control module for the passenger side door mirror to tilt downward to show the position of the curb. The CAN bus also takes inputs from the rain sensor to trigger ...
Multiple-input, multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) is the dominant air interface for 4G and 5G broadband wireless communications. It combines multiple-input, multiple-output technology, which multiplies capacity by transmitting different signals over multiple antennas, and orthogonal frequency-division multiplexing (OFDM), which divides a radio channel into ...
The base station will switch reception to one of two antennas depending on which is currently receiving a stronger signal. For best results, the antennas are usually placed one wavelength apart. For microwave bands, where the wavelengths are under 100 cm, this can often be done with two antennas attached to the same hardware. For lower ...
where is the symbol rate in giga-symbols per second (Gsps), is the bandwidth of OFDM signal, and the factor of 2 is due to the two polarization states in the fiber. There is saving of bandwidth by using multicarrier modulation with orthogonal frequency-division multiplexing.
To combine parallel redundant transmitted longer signal sequences, for example network packets, the principle of a Timing Combiner was defined in 2012. [4] Similarly working like a Selection Combiner , the first fully received and valid data packet will be immediately further processed, whereas the later arriving redundant packets will be ...
Beamforming or spatial filtering is a signal processing technique used in sensor arrays for directional signal transmission or reception. [1] This is achieved by combining elements in an antenna array in such a way that signals at particular angles experience constructive interference while others experience destructive interference.