Search results
Results from the WOW.Com Content Network
Shaped like a “U” or channel to catch water (e.g., where the edge of a tile roof meets a wall). Through wall flashing Spans the thickness of the wall and directs water to weep holes. Cap flashing (drip cap) Often used above windows and doors. Drip edge A metal used at the edges of a roof. Step flashing (soaker, base flashing)
Eaves must be designed for local wind speeds as the overhang can significantly increase the wind loading on the roof. [7] The line on the ground under the outer edge of the eaves is the eavesdrip, or dripline, and in typical building planning regulations defines the extent of the building and cannot oversail the property boundary.
It protects the roof deck from rain before the roofing is installed. It provides an extra weather barrier in case of blow offs or water penetration through the roofing or flashings. It protects the roofing from any resins that bleed out of the sheathing. It helps prevent unevenness in the roof sheathing from telegraphing through the shingles.
A roof must be designed with a suitable fall to allow the rainwater to discharge. The water drains into a gutter that is fed into a downpipe. A flat roof should have a watertight surface with a minimum finished fall of 1 in 80. They can drain internally or to an eaves gutter, which has a minimum 1 in 360 fall towards the downpipe.
A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...
A level architectural deck may be intended for use by people, e.g., what in the UK is usually called a decked patio. "Roof deck" refers to the flat layer of construction materials to which the weather impervious layers are attached to a form a roof, and they may be either level (for a "flat" rooftop) or sloped.
In some cases, a cricket can be used to transition from one roof area to another. On low-slope and flat roofs with parapet walls, crickets are commonly used to divert water to the drainage, against or perpendicular to the main roof slope. The pitch of a cricket is sometimes the same as the rest of the roof, but not always. For Steep-slope roofs ...
A more recent design is the installation of a roof deck with foil-backed foam along with a second deck that is air-gapped away from the foil-backed foam to allow air to flow vertically to a ventilation outlet at the peak of the roof—it is a double-deck design with an air gap. This design improves efficiency. [13]