Search results
Results from the WOW.Com Content Network
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [ 1 ] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units. The standard temperature for metric measurement is 15 degrees Celsius (i.e. 59 degrees Fahrenheit) while for English measurement the standard temperature is 60 °F.
A significant characteristic of the metric system is its use of decimal multiples – powers of 10. For example, a length that is significantly longer or shorter than 1 metre can be represented in units that are a power of 10 or 1000 metres. This differs from many older systems in which the ratio of different units varied.
A metric ounce is an approximation of the imperial ounce, US dry ounce, or US fluid ounce. These three customary units vary. However, the metric ounce is usually taken as 25 or 30 ml (0.88 or 1.06 imp fl oz; 0.85 or 1.01 US fl oz) when volume is being measured, or in grams when mass is being measured.
The statute standardized weight, length and volume as well as introduced the peny, ounce, pound, gallon and bushel. [4]: 73–74 In 1618, the London Pharmacopoeia (medicine compound catalog) adopted the Roman gallon [8] or congius [9] as a basic unit of volume and gave a conversion table to the apothecaries' units of weight. [8]
The U.S. military, reflecting its need to ensure interoperability with its NATO allies, uses metric measurements for almost all weapons calibers, even for calibers that originated as or were derived from a different measurement (e.g., 7.62 mm rather than .308, or 5.56 mm instead of .223). However, civilian rifles chambered for .223 Remington ...
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
There were a number of systems of liquid measurements in the United Kingdom prior to the 19th century. [3] Winchester or corn gallon was 272 in 3 (157 imp fl oz; 4,460 mL) (1697 act 8 & 9 Will. 3. c. 22) Henry VII (Winchester) corn gallon from 1497 onwards was 154.80 imp fl oz (4,398 mL)