Search results
Results from the WOW.Com Content Network
An alternative to G.711 passthrough is the use of ITU-T V.150.1, also known as Modem over IP, which demodulates and remodulates modem data at gateways, forwarding the data over IP between them. This has the advantage that it can also handle some of the signalling aspects of modem connections. [3]
Network address translation between a private network and the Internet. Network address translation (NAT) is a method of mapping an IP address space into another by modifying network address information in the IP header of packets while they are in transit across a traffic routing device. [1]
Network address translation typically uses private IP addresses on private networks with a single public IP address for the router facing the Internet.The network address translator changes the source address in network protocols for outgoing requests from that of an internal device to its external address, so that internal devices can communicate with hosts on the external network, while ...
AT&T Internet provides internet access to computers connected on-premises via Ethernet cabling or Wi-Fi from the included residential gateway or DSL modem. AT&T Fiber, or as it is known AT&T Internet powered by Fiber, [2] provides fiber to the home (FTTH) service in select markets. Historically a form of AT&T Fiber Internet launched in the fall ...
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.