Search results
Results from the WOW.Com Content Network
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]
It breaks down a system into units, and then any number of sub-assemblies. The unit is the highest level of demarcation in a system and is always a numeral. Subsequent demarcation are called assemblies and always have the Class Letter "A" as a prefix following by a sequential number starting with 1.
Schematic diagram of optocoupler. Own work. 00:05, 9 January 2007: 320 × 240 (7 KB) Riflemann~commonswiki: Optocoupler schematic diagram. Own work. File usage.
English: A diagram of a simple circuit using an optocoupler. When the switch S' 1 is closed, the diode emits light and the transistor conducts. v' out thus goes low. This circuit therefore acts much like a logicalNOT gate.
Unlike electronic integration where silicon is the dominant material, system photonic integrated circuits have been fabricated from a variety of material systems, including electro-optic crystals such as lithium niobate, silica on silicon, silicon on insulator, various polymers, and semiconductor materials which are used to make semiconductor lasers such as GaAs and InP.
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
Parts in this section have a pin count of 14 pins or more. The lower part numbers were established in the 1960s and 1970s, then higher part numbers were added incrementally over decades. IC manufacturers continue to make a core subset of this group, but many of these part numbers are considered obsolete and no longer manufactured.
An opto-isolator is a very popular method of isolation in digital circuits. Cross-section of dual in-line package opto-isolators. Relative sizes of LED (red) and sensor (green) are exaggerated. Everlight EL817 phototransistor opto-isolator in DIP-4 package Halo TG110-S050N2RL 10/100BASE-TX Ethernet pulse transformer in SO-16 package.