Search results
Results from the WOW.Com Content Network
In hydrogeology, an aquifer test (or a pumping test) is conducted to evaluate an aquifer by "stimulating" the aquifer through constant pumping, and observing the aquifer's "response" in observation wells. Aquifer testing is a common tool that hydrogeologists use to characterize a system of aquifers, aquitards and flow system boundaries.
Aquifer test (or a pumping test) is a field experiment in which a well is pumped at a controlled rate and the aquifer's response (drawdown) is measured in one or more observation wells. [5] Cone of depression is a conically-shaped depression that is produced in a water table as a result of pumping water from a well at a given rate. [4]
A slug test is in contrast to standard aquifer tests, which typically involve pumping a well at a constant flowrate, and monitoring the response of the aquifer in nearby monitoring wells. Often slug tests are performed instead of a constant rate test, because: time constraints (quick results, or results for a large number of wells, are needed),
Symbol used in drawings Standard penetration test N values from a surficial aquifer in south Florida. The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil. This test is the most frequently used subsurface exploration drilling test performed ...
Typical aquifer cross-section. An unambiguous definition of "groundwater model" is difficult to give, but there are many common characteristics. A groundwater model may be a scale model or an electric model of a groundwater situation or aquifer. Groundwater models are used to represent the natural groundwater flow in the environment.
The concept of permeability is of importance in determining the flow characteristics of hydrocarbons in oil and gas reservoirs, [4] and of groundwater in aquifers. [5]For a rock to be considered as an exploitable hydrocarbon reservoir without stimulation, its permeability must be greater than approximately 100 md (depending on the nature of the hydrocarbon – gas reservoirs with lower ...
Hydraulic tomography (HT) is a sequential cross-hole hydraulic test followed by inversion of all the data to map the spatial distribution of aquifer hydraulic properties. Specifically, HT involves installation of multiple wells in an aquifer, which are partitioned into several intervals along the depth using packers. A sequential aquifer test ...
Typically, a hydrograph is recorded for monitoring of heads in aquifers during non-test conditions (e.g., to observe the seasonal fluctuations in an aquifer). When an aquifer test is being performed, the resulting observations are typically called drawdown, since they are subtracted from pre-test levels and often only the change in water level ...