Search results
Results from the WOW.Com Content Network
Benchtop drill press (left) and floor-standing drill press (right) A drill press is a drilling machine suitable for quick and easy drilling of straight holes, countersinking or counterboring that are perpendicular to both directions of a table surface. In comparison, it is more difficult and less repeatable to drill perpendicularly with a hand ...
Slips is a device used to grip and hold the upper part of a drill string to the drill floor on an oil rig. [1] The slips are constructed as a collection of metal wedges, hinged together to form a circular shape around the drill pipe. On the inside surface, the slips normally has replaceable steel teeth that grips the pipe.
In 1942, Walker-Turner released its first Radial Arm Drill Press, the RD-1170. [1] 900 Series Drill Press, Serial # 1 944. Through 1942-1945, during the years of the United States' involvement in World War II, much of Walker-Turner's production capacity was focused on the war effort. Catalogs and other documentation from this period may be scarce.
Cutting fluids are not used or needed. The main issue in drilling wood is ensuring clean entry and exit holes and preventing burning. Avoiding burning is a question of using sharp bits and the appropriate cutting speed. Drill bits can tear out chips of wood around the top and bottom of the hole and this is undesirable in fine woodworking ...
Machine tapers for tool holding included Morse tapers (on early models) and the R8 taper (a widely used standard that Bridgeport created) on most models. Both Morse and R8 allowed for both collets and solid holders, and a drill chuck could be held by either of the latter. Currently R8 and Erickson #30 Quick Change tool holders are available.
In 1919 the Pennimans filed an unfair trade lawsuit against Eames (Atlas Press Co. v. Eames), claiming rights over the trademark, patent and improved design. The case was argued in front of the Michigan Supreme Court, which ruled that Eames had to cease use of the trademark, but refusing the transfer of the improved press to the Atlas company. [3]
Goodell-Pratt was a tool manufacturing company based in Greenfield, Massachusetts.. The company was founded in 1888 as the Goodell Brothers Company by Albert and Henry E. Goodell, and was located in Shelburne Falls, Massachusetts.
There are several kinds of underbalanced drilling. The most common are listed below. Dry air. This is also known as dusting. Here air compressors combined with a booster (which takes the head from the compressors and increases the pressure of the air, but does not increase the volume of air going down hole) are used and the only fluid injected into the well is a small amount of oil to reduce ...