Search results
Results from the WOW.Com Content Network
Drills that use side jumps and front-back jumps are more specific to team sports in which the athlete must change direction while running. Drills that require jumping over objects is usually best suited for sports in which the player must leap over hurdles or players. These drills usually use some form of rope ladders, small or low hurdles ...
The PEPCON plant, located in Henderson, Nevada, 10 miles (16 km) from Las Vegas, was one of only two American producers of ammonium perchlorate ("AP"), an oxidizer used in solid propellant rockets, including the Space Shuttle boosters, Trident SLBMs, and other rockets such as the Patriot. [3]
Change of direction (COD) is any activity that involves a rapid whole-body movement with a pre-planned change of velocity or direction. In elite sports , the speed at which an athlete can do a change of direction is especially valuable in court and field sports.
The 20-yard shuttle, also simply called the short shuttle, is a timed agility drill run primarily to evaluate athletes’ quickness and change-of-direction ability. Although not as highly regarded as the 40-yard dash, it is still an important measure used by NFL personnel to compare players. Canadian football also uses the shuttle test. [12]
The drill team at Dodge City High School was performing at its Winter Pep Assembly on Thursday, Dec. 8, and Shane Harris made an appearance 20 seconds into the act. ... Harris “walked it out ...
The three-cone drill, 3-cone drill or L-drill is a test performed by American football players. It is primarily run to evaluate the agility, quickness and fluidity of movement of players by scouts . It is most commonly seen at the NFL Combine in preparation for the NFL draft but is also an important measurement for collegiate recruiting .
The pitch surface of bevel gears is a cone, known as a pitch cone. Bevel gears change the axis of rotation of rotational power delivery and are widely used in mechanical settings. Bevel gear on roller shutter door. Regardless of the operating angle, the gear axes must intersect (at a point O) Bevel gear lifts floodgate by means of central screw.
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.