Search results
Results from the WOW.Com Content Network
Based on Bill Denison's hydraulics expertise—the Denison company was to go on to produce more than 600 patents during the twentieth century. [ 6 ] The most prominent engineer was Ellis Born, (October 11, 1919 - Monday, March 19, 2007 [ 7 ] ) graduated in 1941 from the Ohio State University with a Bachelor of Science in mechanical engineering.
A critical element in vane pump design is how the vanes are pushed into contact with the pump housing, and how the vane tips are machined at this very point. Several type of "lip" designs are used, and the main objective is to provide a tight seal between the inside of the housing and the vane, and at the same time to minimize wear and metal-to ...
An eccentric rotary vane pump Another eccentric rotary-vane pump design. Note that modern pumps have an area contact between rotor and stator (and not a line contact). 1. pump housing 2. rotor 3. vanes 4. spring. A rotary vane pump is a type of positive-displacement pump that consists of vanes mounted to a rotor that rotates inside a cavity. In ...
A fluid flow conditioning device, the cheng rotation vane (CRV) is a stationary vane [1] fabricated within a pipe piece as a single unit and welded directly upstream of an elbow before the pump inlet, flow meters, compressors, or other downstream equipment.
Piston pumps can be made variable-displacement by inserting springs inline with the pistons. The displacement is not positively controlled, but decreases as back-pressure increases. Another variation is the variable-displacement vane pump, a type that has found usage in motor vehicle automatic transmissions, such as the General Motors Hydra-Matic.
A peristaltic pump, also commonly known as a roller pump, is a type of positive displacement pump used for pumping a variety of fluids. The fluid is contained in a flexible tube fitted inside a circular pump casing. Most peristaltic pumps work through rotary motion, though linear peristaltic pumps have also been made.
Piston and vane are both pump and motor. If vane is no (good) motor, it is because it intrinsec geometric deficiency that very few know about. This bridge info is most fundamental and valuable to readers. — Preceding unsigned comment added by 96.22.59.92 16:20, 25 October 2012 (UTC)
Piston pump compared to a plunger pump. A piston pump is a type of positive displacement pump where the high-pressure seal reciprocates with the piston. [1] Piston pumps can be used to move liquids or compress gases. They can operate over a wide range of pressures. High pressure operation can be achieved without adversely affecting flow rate.