Search results
Results from the WOW.Com Content Network
The most widely used definition was developed in 1964 by D. U. Deere. It is the borehole core recovery percentage incorporating only pieces of solid core that are longer than 100 mm in length measured along the centerline of the core. In this respect pieces of core that are not hard and sound should not be counted though they are 100 mm in length.
The first large-scale SCR was installed by the IHI Corporation in 1978. [1] Commercial selective catalytic reduction systems are typically found on large utility boilers, industrial boilers, and municipal solid waste boilers and have been shown to lower NO x emissions by 70-95%. [1]
ICAP-SCR—Installed capacity special case resources (electricity) ICCP—Inter-Control Center Communications Protocol (electricity) ICE—Internal combustion engine (transportation) ICT—Independent Coordinator of Transmission (US) (electricity) —Information and Communication Technology; IDC—Interchange Distribution Calculator (electricity)
Rock Structure Rating (RSR) is a quantitative method for describing quality of a rock mass and appropriate ground support, in particular, for steel-rib support, developed by Wickham, Tiedemann and Skinner.
Opto-isolator, opto-coupler, photo-coupler – photodiode, BJT, JFET, SCR, TRIAC, zero-crossing TRIAC, open collector IC, CMOS IC, solid state relay (SSR) Slotted optical switch, opto switch, optical switch; LED display – seven-segment display, sixteen-segment display, dot-matrix display
The thyristor power controller switches 60% of the solid waves to the load while blocking 40%. The operating mode is to be regarded as unproblematic. Only in the case of a too weakly designed network, it is possible for illuminating installations which are connected to the same network to have undesired luminance fluctuations (flicker effect).
A silicon-controlled switch (SCS) behaves nearly the same way as an SCR; but there are a few differences. Unlike an SCR, an SCS switches off when a positive voltage/input current is applied to another anode gate lead. Unlike an SCR, an SCS can be triggered into conduction when a negative voltage/output current is applied to that same lead.
In the pool type, the primary coolant is contained in the main reactor vessel, which therefore includes the reactor core and a heat exchanger. The US EBR-2, French Phénix and others used this approach, and it is used by India's Prototype Fast Breeder Reactor and China's CFR-600. In the loop type, the heat exchangers are outside the reactor tank.