Search results
Results from the WOW.Com Content Network
The JFET is externally-powered by the DC voltage V + through a resistor which sets the gain and output impedance. The output audio signal is received though a DC blocking capacitor . An electret microphone is a microphone whose diaphragm forms a capacitor (historically-termed a condenser ) that incorporates an electret .
This current dependency is not supported by the characteristics shown in the diagram above a certain applied voltage. This is the saturation region, and the JFET is normally operated in this constant-current region where device current is virtually unaffected by drain-source voltage. The JFET shares this constant-current characteristic with ...
The mode can be determined by the sign of the threshold voltage (gate voltage relative to source voltage at the point where an inversion layer just forms in the channel): for an N-type FET, enhancement-mode devices have positive thresholds, and depletion-mode devices have negative thresholds; for a P-type FET, enhancement-mode have negative ...
The easiest way to tell if a FET is common source, common drain, or common gate is to examine where the signal enters and leaves. The remaining terminal is what is known as "common". In this example, the signal enters the gate, and exits the drain. The only terminal remaining is the source. This is a common-source FET circuit.
FlexFET is a planar, independently double-gated transistor with a damascene metal top gate MOSFET and an implanted JFET bottom gate that are self-aligned in a gate trench. . This device is highly scalable due to its sub-lithographic channel length; non-implanted ultra-shallow source and drain extensions; non-epi raised source and drain regions; and gate-last fl
The U 47 FET, the solid-state version introduced by Neumann in 1969, was less appreciated as a vocal microphone but became ubiquitous in studios as a bass drum microphone. Used on the outside of the bass drum, in conjunction with a primary bass drum microphone (which would usually be placed on the inside, or close to the inside of a bass drum ...
MK, MIC: Microphone: MP: Mechanical part (including screws and fasteners) OP: Opto-isolator: often changed to "U" for IC P: Plug (most-movable connector of a connector pair), plug connector (connector may have "male" pin contacts and/or "female" socket contacts) PD: Photodiode: Q: Transistor (all types) R: Resistor: RN: Resistor network
to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.