Search results
Results from the WOW.Com Content Network
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
Cable length: Length: Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume ...
The NIST document gives conversion factors correct to 7 places. Factors in bold are exact. If exact factors have more than 7 places, they are rounded and no longer exact. This convert module replaces these rounded figures with the exact figures. For example, the NIST document has 1 square mile = 2.589 988 E+06 square meters.
Knots tied at a distance of 47 feet 3 inches (14.4018 m) from each other, passed through a sailor's fingers, while another sailor used a 30-second sand-glass (28-second sand-glass is the currently accepted timing) to time the operation. [9] The knot count would be reported and used in the sailing master's dead reckoning and navigation.
In enzymology, the turnover number (k cat) is defined as the limiting number of chemical conversions of substrate molecules per second that a single active site will execute for a given enzyme concentration [E T] for enzymes with two or more active sites. [1] For enzymes with a single active site, k cat is referred to as the catalytic constant. [2]
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples:
The conversion between different SI units for one and the same physical quantity is always through a power of ten. This is why the SI (and metric systems more generally) are called decimal systems of measurement units. [10] The grouping formed by a prefix symbol attached to a unit symbol (e.g. ' km ', ' cm ') constitutes a new inseparable unit ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.