enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Ribbon cable is designed to be used with multi-contact IDC connectors in such a way that many IDC connections can be made at once, saving time in applications where many connections are needed. These connectors are not designed to be reusable, but can often be re-used if care is taken when removing the cable.

4. Micro ribbon connector - Wikipedia

   en.wikipedia.org/wiki/Micro_ribbon_connector

   The micro ribbon or miniature ribbon connector is a common type of electrical connector for a variety of applications, such as in computer and telecommunications equipment having many contacts. The connector contains two parallel rows of contacts within a shielded case having a characteristic D-shape similar to that used in D-subminiature ...

5. 110 block - Wikipedia

   en.wikipedia.org/wiki/110_block

   A 110 punch block. A 110 block is a type of punch-down block used to terminate runs of on-premises wiring in a structured cabling system. The designation 110 is also used to describe a type of insulation displacement contact (IDC) connector used to terminate twisted pair cables, [1] which uses a punch-down tool similar to the type used for the older 66 block.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   A common example is the multi-conductor flat ribbon cable used in computer disk drives; to terminate each of the many (approximately 40) wires individually would be slow and error-prone, but an insulation displacement connector can terminate all the wires in a single action.

7. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   Pin headers with a plastic guide box around them are known as a shrouded header or box header (BH) and are normally used in combination with insulation-displacement connectors (IDC) for ribbon cables. A square notch (key) in the shroud prevents placing the connector (polarised by a "bump" on one side) the wrong way around. [4]