Search results
Results from the WOW.Com Content Network
The BNC connector is used for analog composite video and digital video interconnects on commercial video devices. Consumer electronics devices with RCA connector jacks can be used with BNC-only commercial video equipment by inserting an adapter. BNC connectors were commonly used on 10base2 thin Ethernet network cables and network cards. BNC ...
Where BNC is used, available as 3 connectors with Sync on Green, or 5 connector Red / Green / Blue / Horizontal Sync / Vertical sync. Mac-II/Quadra DA15F: 1152 × 870 @ 75 [8] Macintosh: Mac-DA15F and Sun-13W3 were similar in capability to VGA. Some Sun machines used 4 or 5 BNC connectors to transfer video signal. 1990: 13W3 DB13W3: 1152 × 900 ...
RG-59 coaxial cable is commonly packed with consumer equipment, such as VCRs or digital cable/satellite receivers. Manufacturers tend to include only RG-59 cables because it costs less than RG-6 does. However, given the short lengths provided (usually 4–6 ft or 1.2–1.8 m), this is generally sufficient for its typical use.
The F connector is an inexpensive, gendered, threaded, compression connector for radio frequency signals. It has good 75 Ω impedance match for frequencies well over 1 GHz [2] and has usable bandwidth up to several GHz. Connectors mate using a 3/8-32UNEF thread. The female connector has a socket for the center conductor and external threads.
SR connector (from Russian: Cоединитель Pадиочастотный) is a Russian RF connector, based on the BNC connector and which comes in a 50 Ω and 75 Ω versions; TNC connector (threaded Neill-Concelman) Twin-BNC (Twinax) Twinax connectors are used with 78 Ω or 95 Ω conductor cables and operate from 0–200 MHz. Due to ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...