enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IEC metric screw sized connectors - Wikipedia

   en.wikipedia.org/wiki/IEC_metric_screw_sized...

   M12 A-coded 5-pin connector: For each connector size, the A-coding is the inspecific pinout variant and the only variant defined in varying numbers of pins. Ethernet cable with an M12 X-coded connector in one end and a modular connector in the other.

3. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

4. EIAJ connector - Wikipedia

   en.wikipedia.org/wiki/EIAJ_connector

   This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).. Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.

5. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   Hose link is a 1/4-turn bayonet-mount garden hose connection, which uses an o-ring to o-ring seal. It was designed by Hoselink, Pty, Ltd., Australia, [24] and patented in 1998. [25] It is popular in Australia, with limited distribution in the UK and the US, where it is distributed by Dayco Products, Inc.

6. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.

7. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   A 5 ⁄ 16 inch torque wrench is required for this, set to 3–5 in·lbf (0.3 to 0.6 N·m) for brass, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors. Flats are sometimes also provided on the cable side of the connector assembly so that a second wrench can be used to prevent it from rotating and damaging the joint to the cable.