Search results
Results from the WOW.Com Content Network
The Optical Internetworking Forum in 2016 published the CFP2-ACO or CFP2 - Analog Coherent Optics Module Interoperability Agreement (IA). This IA supports a configuration where the digital signal processor (DSP) is on the main board and analog optical components are on the module.
The schematic diagram of a radio does not show the width of each connection in the printed circuit board, but the layout does. To make an analogy to the map making world, a block diagram is similar to a highway map of an entire nation. The major cities (functions) are listed but the minor county roads and city streets are not.
Digital readout integrated circuit (DROIC) block diagram. A Digital readout integrated circuit (DROIC) is a class of ROIC that uses on-chip analog-to-digital conversion (ADC) to digitize the accumulated photocurrent in each pixel of the imaging array. DROICs are easier to integrate into a system compared to ROICs as the package size and ...
English: Block diagram of a tuned radio frequency (TRF) receiver, the simplest type of amplifying radio receiver circuit. It consists of one or more tuned RF amplifiers, each consisting of a tuned circuit which functioned as a bandpass filter followed by a radio frequency (RF) amplifier; a detector (demodulator) to extract the audio waveform from the radio carrier wave; followed by an audio ...
Unlike electronic integration where silicon is the dominant material, system photonic integrated circuits have been fabricated from a variety of material systems, including electro-optic crystals such as lithium niobate, silica on silicon, silicon on insulator, various polymers, and semiconductor materials which are used to make semiconductor lasers such as GaAs and InP.
An optical module is a typically hot-pluggable optical transceiver used in high-bandwidth data communications applications. Optical modules typically have an electrical interface on the side that connects to the inside of the system and an optical interface on the side that connects to the outside world through a fiber optic cable.
Block diagram of a superheterodyne receiver. The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1]
Schematic diagram of an opto-isolator showing source of light (LED) on the left, dielectric barrier in the center, and sensor (phototransistor) on the right [note 1]. An opto-isolator (also called an optocoupler, photocoupler, or optical isolator) is an electronic component that transfers electrical signals between two isolated circuits by using light. [1]