Search results
Results from the WOW.Com Content Network
As with seven and fourteen-segment displays, a decimal point and/or comma may be present as an additional segment, or pair of segments; the comma (used for triple-digit groupings or as a decimal separator in many regions) is commonly formed by combining the decimal point with a closely 'attached' leftwards-descending arc-shaped segment. This ...
The stated distance is 360 km (220 mi); the comma is the decimal separator in Germany. 10,000 meters; About 6.2 miles; 1 mil (the Scandinavian mile), now standardized as 10 km: 1 mil, the unit of measure commonly used in Norway and Sweden [152] used to be 11,295 m in Norway and 10,688 m in Sweden.
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The CBR test is a penetration test in which a standard piston, with a diameter of 50 mm (1.969 in), is used to penetrate the soil at a standard rate of 1.25 mm/minute. Although the force increases with the depth of penetration, in most cases, it does not increase as quickly as it does for the standard crushed rock, so the ratio decreases.
Although its shells, 50 x 228 mm, are twice the diameter of the 25×137mm cartridge of the M242, the 50mm cannon is not much longer than the smaller weapon. [2] The overall lengths of the 25mm cannon and 50mm cannon are 105.2 inches (267 cm) and 117.7 inches (299 cm), respectively; while the portion of the gun that intrudes into the turret are ...
Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think about them ["two-fifty", "five hundred", "seven-fifty"]. Machinists generally ...
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
This is a list of firearm cartridges which have bullets in the 11 millimetres (0.43 in) to 11.99 millimetres (0.472 in) caliber range.. Length refers to the cartridge case length