Ads
related to: water to mix with antifreeze
Search results
Results from the WOW.Com Content Network
Most antifreeze is made by mixing distilled water with additives and a base product, usually MEG (mono ethylene glycol) or MPG (mono propylene glycol). Ethylene glycol solutions first became available in 1926 and were marketed as "permanent antifreeze" since the higher boiling points provided advantages for summertime use as well as during cold ...
There is a difference in the mixing ratio, depending on whether it is ethylene glycol or propylene glycol. For ethylene glycol, the mixing ratios are typically 30/70 and 35/65, whereas the propylene glycol mixing ratios are typically 35/65 and 40/60. It is important that the mixture be frost-proof at the lowest operating temperature. [24]
A heat transfer fluid, usually water or water mixed with antifreeze (propylene glycol, ethanol or methanol), is circulated through this pipe, warming or cooling to the temperature of the earth or rock around it. In open loop systems the pipe draws water from a well, lake or pond.
[7] [22] Water-propylene glycol mixtures dyed pink to indicate the mixture is relatively nontoxic are sold under the name of RV or marine antifreeze. Propylene glycol is frequently used as a substitute for ethylene glycol in low toxicity, environmentally friendly automotive antifreeze.
Mixing solvents creates cooling baths with variable freezing points. Temperatures between approximately −78 °C and −17 °C can be maintained by placing coolant into a mixture of ethylene glycol and ethanol, [1] while mixtures of methanol and water span the −128 °C to 0 °C temperature range.
Indirect or closed loop systems use a heat exchanger to transfer heat from the "heat-transfer fluid" (HTF) fluid to the potable water. The most common HTF is an antifreeze/water mix that typically uses non-toxic propylene glycol. After heating in the panels, the HTF travels to the heat exchanger, where its heat is transferred to the potable water.
Water typically enters residences in the US at about 10 °C (50 °F), depending on latitude and season. Hot water temperatures of 50 °C (122 °F) are usual for dish-washing, laundry and showering, which requires that the heater raise the water temperature about 40 °C (72 °F) if the hot water is mixed with cold water at the point of use.
In automobiles and motorcycles with a liquid-cooled internal combustion engine, a radiator is connected to channels running through the engine and cylinder head, through which a liquid is pumped by a coolant pump. This liquid may be water (in climates where water is unlikely to freeze), but is more commonly a mixture of water and antifreeze in ...
Ads
related to: water to mix with antifreeze