Search results
Results from the WOW.Com Content Network
A guide to the recoil from the cartridge, and an indicator of bullet penetration potential. The .30-06 Springfield (at 2.064 lbf-s) is considered the upper limit for tolerable recoil for inexperienced rifle shooters. [2] Chg: Propellant charge, in grains; Dia: Bullet diameter, in inches; BC: Ballistic coefficient, G1 model; L: Case length (mm)
The ballistic coefficient of an atmospheric reentry vehicle has a significant effect on its behavior. A very high ballistic coefficient vehicle would lose velocity very slowly and would impact the Earth's surface at higher speeds. In contrast, a low ballistic coefficient vehicle would reach subsonic speeds before reaching the ground. [75]
Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...
Most VLD bullets are used in rifles. VLD bullets typically have a ballistic coefficient greater than 0.5, although the threshold is undefined. [1] Bullets with a lower drag coefficient decelerate less rapidly. A low drag coefficient flattens the projectile's trajectory and also markedly decreases the lateral drift caused by crosswinds. The ...
Sectional density has the same (implied) units as the ballistic coefficient. Within terminal ballistics, the sectional density of a projectile is one of the determining factors for projectile penetration. The interaction between projectile (fragments) and target media is however a complex subject. A study regarding hunting bullets shows that ...
Here is an example of a ballistic table for a .30 calibre Speer 169 grain (11 g) pointed boat tail match bullet, with a BC of 0.480. It assumes sights 1.5 inches (38 mm) above the bore line, and sights adjusted to result in point of aim and point of impact matching 200 yards (183 m) and 300 yards (274 m) respectively.
A popular 7 mm hunting caliber bullet is actually .283 in diameter (7.2 mm), but wildcat cartridges using this caliber bullet in a 5.56 x 45 case have so far not been successful. There is an existing and well-developed use of hunting-rifle bullets in the .277 caliber (6.8 mm), introduced by Winchester as the 270 in 1925.
With a 165-grain bullet, the 6.8 Western is capable of matching the muzzle velocity of a .270 Winchester loaded with a 150-grain bullet. The higher ballistic coefficient of the 6.8 Western results in a flatter trajectory at distances beyond 600 yards, which may be controversial for hunting purposes.