Search results
Results from the WOW.Com Content Network
If using the metric unit meters for distance and the imperial unit inches for target size, one has to multiply by a factor of 25.4, since one inch is defined as 25.4 millimeters. distance in meters = target in inches angle in mrad × 25.4 {\displaystyle {\text{distance in meters}}={\frac {\text{target in inches}}{\text{angle in mrad}}}\times 25.4}
A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10 −4 mm 2. It is a unit intended for referring to the area of a wire with a circular cross section.
In the United States, mil was once the more common term, [10] [11] but as use of the metric system has become more common, thou has replaced mil among most technical users to avoid confusion with millimetres. [10] [11] [12] Today both terms are used, but in specific contexts one is traditionally preferred over the other.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
6.45160 × 10 −4 mm 2: A square mil is a unit of area, equal to the area of a square with sides of length one mil. A mil is one thousandth of an international inch.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Thickness of aluminum foil is measured in mils (1 ⁄ 1000 inch, or 0.0254 mm) in the United States. Cross-sectional area of electrical wire is measured in circular mils in the U.S. and Canada, one circular mil (cmil) being equal to 5.067 × 10 −4 mm 2 (or 7.854 × 10 −7 in 2). Since this is so small, actual wire is commonly measured in ...