enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Total recordable incident rate - Wikipedia

    en.wikipedia.org/wiki/Total_Recordable_Incident_Rate

    The total recordable incident rate (TRIR) is a measure of occupational safety and health, useful for comparing working conditions in workplaces and industries.It is calculated by combining the actual number of safety incidents and total work hours of all employees with a standard employee group (100 employees working 40 hours a week for 50 weeks a year).

  3. Permissible exposure limit - Wikipedia

    en.wikipedia.org/wiki/Permissible_exposure_limit

    The current PEL for OSHA standards are based on a 5 decibel exchange rate. OSHA's PEL for noise exposure is 90 decibels (dBA) for an 8-hour TWA. Levels of 90-140 dBA are included in the noise dose. [4] PEL can also be expressed as 100 percent “dose” for noise exposure. When the noise exposure increases by 5 dB, the exposure time is cut in ...

  4. Occupational Safety and Health Act (United States) - Wikipedia

    en.wikipedia.org/wiki/Occupational_Safety_and...

    Section 8 permits OSHA inspectors to enter, inspect and investigate, during regular working hours, any workplace covered by the Act. [25] Employers must also communicate with employees about hazards in the workplace. By regulation, OSHA requires that employers keep a record of every non-consumer chemical product used in the workplace.

  5. Taser safety issues - Wikipedia

    en.wikipedia.org/wiki/Taser_safety_issues

    Special precautions should be taken when a Taser dart is being removed from sensitive areas. [33] Disposal issues: Proper disposal of the contaminated darts includes placing the probes into a puncture-resistant, leak-proof container. [30] OSHA requirements and the Bloodborne Pathogen Protocols should be followed when removing a Taser probe. [34]

  6. Chief of California’s OSHA program steps down as agency ...

    www.aol.com/chief-california-osha-program-steps...

    Killip presented data at a November Cal-OSHA advisory committee meeting that showed a nearly 35% vacancy rate among site safety inspector classifications. The data also showed the attrition rate ...

  7. Occupational safety and health - Wikipedia

    en.wikipedia.org/wiki/Occupational_safety_and_health

    Rate of fatal work injuries per 100,000 full-time equivalent workers by employee status, 2006–17. Rate = (fatal work injuries/total hours worked by all workers) × 200,000,000 where 200,000,000 = base for 100,000 full-time equivalent workers (FTEs) working 40 hours per week, 50 weeks per year.

  8. Accident triangle - Wikipedia

    en.wikipedia.org/wiki/Accident_triangle

    The triangle was widely used in industrial health and safety programs over the following 80 years and was described as a cornerstone of health and safety philosophy. [2] [1] Heinrich's theory also suggested that 88% of all accidents were caused by a human decision to carry out an unsafe act. [2]

  9. What is a factor rate and how to calculate it - AOL

    www.aol.com/finance/factor-rate-calculate...

    How to calculate a factor rate. Using the factor rate provided by the lender, you can quickly calculate the cost of the borrowed funds. For example, if you borrowed $100,000 with a factor rate of ...