enow.com Web Search

  1. Ads

    related to: replace bathroom sink water supply lines

Search results

  1. Results from the WOW.Com Content Network
  2. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

  3. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [21]

  4. How homeowners can prevent pipes from freezing during winter

    www.aol.com/weather/homeowners-prevent-pipes...

    Check throughout the home for areas where water supply lines are located in unheated areas of the house. "Take measures to prevent the flow of cold air in these areas," Green Apple Mechanical said.

  5. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In-line vent (also known as an island fixture vent, and, colloquially, a "Chicago Loop", "Boston loop" or "Bow Vent") is an alternate method permissible in some jurisdictions of venting the trap installed on an under counter island sink or other similar applications where a conventional vertical vent stack or air admittance valve is not ...

  6. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...

  7. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Taps are normally connected to the water supply by means of a "swivel tap connector", which is attached to the end of the water pipe using a soldered or compression fitting, and has a large nut to screw onto the threaded "tail" of the tap, which hangs down underneath the bath, basin or sink.

  1. Ads

    related to: replace bathroom sink water supply lines