enow.com Web Search

  1. Ad

    related to: how to check injector circuit

Search results

  1. Results from the WOW.Com Content Network
  2. Test point - Wikipedia

    en.wikipedia.org/wiki/Test_point

    Testpoints on a printed circuit board (labelled E34, E35, E36, …) next to teardrop vias. A test point is a location within an electronic circuit that is used to either monitor the state of the circuitry or to inject test signals. [1] Test points have three primary uses: During development they are used to analyze hardware behavior.

  3. Current injection technique - Wikipedia

    en.wikipedia.org/wiki/Current_injection_technique

    To implement the current injection technique, current injection circuit was developed with results indicating that the injection of an additional current during its switching transient can reduce the reverse recovery charge of a given power diode and thyristor, and also reduce the tail current of insulated gate bipolar transistors.

  4. Electronically controlled unit injector - Wikipedia

    en.wikipedia.org/wiki/Electronically_controlled...

    An electronically controlled unit injector (EUI) sometimes referred to as a mechanical electronic unit injector (MEUI) is a unit injector (UI) with electronic control. It performs the same function as a conventional unit injector in an internal combustion engine , such as in an on-road or off-road vehicle or a diesel-electric locomotive .

  5. In-circuit testing - Wikipedia

    en.wikipedia.org/wiki/In-circuit_testing

    While in-circuit test is a very powerful tool for testing PCBs, it has these limitations: Parallel components can often only be tested as one component if the components are of the same type (i.e. two resistors); though different components in parallel may be testable using a sequence of different tests - e.g. a DC voltage measurement versus a measurement of AC injection current at a node.

  6. Thermotime switch - Wikipedia

    en.wikipedia.org/wiki/Thermotime_switch

    A thermotime switch, or TTS, is a sensor used to control the cold start enrichment process in some older fuel injection systems. An extra injector is placed in the inlet manifold designed to feed all of the cylinders, and whilst the other injectors have flow rates controlled by pulse duration, the cold start injector stays on during the initial cold starting procedure.

  7. Lucas 14CUX - Wikipedia

    en.wikipedia.org/wiki/Lucas_14CUX

    The Lucas 14CUX (sometimes referred to as the Rover 14CUX) is an automotive electronic fuel injection system developed by Lucas Industries and fitted to the Rover V8 engine in Land Rover vehicles between 1990 and 1995. [1] The system was also paired with the Rover V8 by a number of low-volume manufacturers such as TVR, Marcos, Ginetta, and Morgan.

  8. How to Get Rid of Blisters, According to Doctors - AOL

    www.aol.com/rid-blisters-according-doctors...

    BLISTERS MIGHT NOT seem like a big deal—until you get one and remember how debilitating they can be. These painful skin lesions are caused by friction when your skin rubs against your shoes ...

  9. Integrated injection logic - Wikipedia

    en.wikipedia.org/wiki/Integrated_injection_logic

    Integrated injection logic (IIL, I 2 L, or I2L) is a class of digital circuits built with multiple collector bipolar junction transistors (BJT). [1] When introduced it had speed comparable to TTL yet was almost as low power as CMOS , making it ideal for use in VLSI (and larger) integrated circuits .

  1. Ad

    related to: how to check injector circuit