Search results
Results from the WOW.Com Content Network
A defective pixel or a dead pixel is a pixel on a liquid crystal display (LCD) that is not functioning properly. The ISO standard ISO 13406-2 distinguishes between three different types of defective pixels, [ 1 ] while hardware companies tend to have further distinguishing types.
Most LCD monitors are able to inform the PC of their native resolution using Extended display identification data (EDID); however, some LCD TVs, especially those with 1366x768 pixels, fail to provide their native resolution and only provide a set of lower resolutions, resulting in a less than pixel perfect output.
Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin). The modern DE-15 connector can carry Display Data Channel to allow the monitor to communicate with the graphics card, and optionally vice versa. [1] Being replaced by DVI from 1999 onward. DB13W3
Display Stream Compression (DSC) is a VESA-developed video compression algorithm designed to enable increased display resolutions and frame rates over existing physical interfaces, and make devices smaller and lighter, with longer battery life. [1] It is a low-latency algorithm based on delta PCM coding and YC G C O-R color space. [1] [2]
Display lag contributes to the overall latency in the interface chain of the user's inputs (mouse, keyboard, etc.) to the graphics card to the monitor. Depending on the monitor, display lag times between 10-68 ms have been measured. However, the effects of the delay on the user depend on each user's own sensitivity to it.
Almost all Amiga models present the same color sequence when turned on: black screen, dark gray, light gray color screens filling all monitor screen in a rapid sequence (Amigas usually take between 2 and 3 seconds to turn on and boot). [9]
The single fixed-screen mode used in first-generation (128k and 512k) Apple Mac computers, launched in 1984, with a monochrome 9" CRT integrated into the body of the computer. Used to display one of the first mass-market full-time GUIs, and one of the earliest non-interlaced default displays with more than 256 lines of vertical resolution.
Direct Drive Monitor (DDM) 1.0 standard was approved in December 2008. It allows for controller-less monitors where the display panel is directly driven by the DisplayPort signal, although the available resolutions and color depth are limited to two-lane operation.