Search results
Results from the WOW.Com Content Network
Refrigerated dryers employ two heat exchangers, one for air-to-air and one for air-to-refrigeration. However, there is also a single TRISAB heat exchanger that combines both functions. The compressors used in this type of dryer are usually of the hermetic type and the most common gas used is R-134a and R-410a for smaller air dryers up to 100 ...
The drying cost is made up of two parts: the capital cost and the operating cost. Capital cost is largely depend on the drying rate requirement, and equipment cost. Operating cost refers to fuel, electricity and labor force cost. The amount of energy required to dry a bushel of grain is similar for all the drying methods.
The therm (symbol, thm) is a non-SI unit of heat energy equal to 100,000 British thermal units (BTU), [1] and approximately 105 megajoules, 29.3 kilowatt-hours, 25,200 kilocalories and 25.2 thermies. One therm is the energy content of approximately 100 cubic feet (2.83 cubic metres) of natural gas at standard temperature and pressure. However ...
The current national gas price average is $3.62 per gallon. The average cost of gas has decreased 15% in the last two years, from when it was $4.27 per gallon. The highest recorded average price ...
The bypass ratio (BPR) of a turbofan engine is the ratio between the mass flow rate of the bypass stream to the mass flow rate entering the core. [1] A 10:1 bypass ratio, for example, means that 10 kg of air passes through the bypass duct for every 1 kg of air passing through the core.
The spray drying technique was first described in 1860 with the first spray dryer instrument patented by Samuel Percy in 1872. [citation needed] With time, the spray drying method grew in popularity, at first mainly for milk production in the 1920s and during World War II, when there was a need to reduce the weight and volume of food and other materials.
A 1 inch tall uranium fuel pellet is equivalent to about 1 ton of coal, 120 gallons of crude oil, or 17,000 cubic feet of natural gas. [15] In light-water reactors , 1 kg of natural uranium – following a corresponding enrichment and used for power generation– is equivalent to the energy content of nearly 10,000 kg of mineral oil or 14,000 ...
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]