enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]

  3. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]

  4. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    A characteristic of the eastern school is close studding which is a half-timbering style of many studs spaced about the width of the studs apart (for example six-inch studs spaced six inches apart) until the middle of the 16th century and sometimes wider spacing after that time. Close studding was an elite style found mostly on expensive buildings.

  5. Using a stud finder or stud finder app are foolproof ways to find wall studs, but you can find a wall stud manually with code measurements, knocking, and more. 8 Foolproof Ways to Find Wall Studs ...

  6. Steel frame - Wikipedia

    en.wikipedia.org/wiki/Steel_frame

    Interior partition walls made with cold-formed steel. Cold-formed steel frames are also known as lightweight steel framing (LSF). Thin sheets of galvanized steel can be cold formed into steel studs for use as a structural or non-structural building material for both external and partition walls in both residential, commercial and industrial construction projects (pictured).

  7. This Hack Will Ensure You ALWAYS Hit A Stud - AOL

    www.aol.com/lifestyle/hack-ensure-always-hit...

    The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.

  8. Sound transmission class - Wikipedia

    en.wikipedia.org/wiki/Sound_transmission_class

    Interior walls with 1 sheet of 1 ⁄ 2-inch (13 mm) gypsum wallboard on either side of 2x4 (1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in or 38 mm × 89 mm) wood studs spaced 16 inches (410 mm) on-center with no fiberglass insulation filling each stud cavity have an STC of about 33. [14]

  9. Dwang - Wikipedia

    en.wikipedia.org/wiki/Dwang

    In construction, a dwang Scotland and New Zealand, [1] [2] [3] nogging piece, nogging, noggin or nog (all derived from brick nog) [4] [5] England and Australia, or blocking North America, is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.