enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Treenail - Wikipedia

   en.wikipedia.org/wiki/Treenail

   The mortise is drilled 1 ⁄ 16 inch (1.6 mm) smaller than the treenail to create a tight fit and take advantage of friction in the mortise. In cases where the treenail is 24 inches (61 cm) or longer, the treenail should be shaped 1 ⁄ 8 inch (3.2 mm) smaller than the other half. In the same case the mortise is drilled in two parts, with a ...

3. Dowel - Wikipedia

   en.wikipedia.org/wiki/Dowel

   A dowel plate. The traditional tool for making dowels is a dowel plate, an iron (or better, hardened tool steel) plate with a hole having the size of the desired dowel.To make a dowel, a piece of wood is split or whittled to a size slightly bigger than desired and then driven through the hole in the dowel plate.

4. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.

5. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

6. Quarter sawing - Wikipedia

   en.wikipedia.org/wiki/Quarter_sawing

   In addition to the grain, quartersawn wood (particularly oak) will also often display a pattern of medullary rays, seen as subtle wavy ribbon-like patterns across the straight grain. [6] Medullary rays grow in a radial fashion in the living tree, so while flat-sawing would cut across the rays, quarter-sawing puts them on the face of the board.

7. Rod (unit) - Wikipedia

   en.wikipedia.org/wiki/Rod_(unit)

   The rod, perch, or pole (sometimes also lug) is a surveyor's tool [1] and unit of length of various historical definitions. In British imperial and US customary units, it is defined as 16 + 1 ⁄ 2 feet, equal to exactly 1 ⁄ 320 of a mile, or 5 + 1 ⁄ 2 yards (a quarter of a surveyor's chain), and is exactly 5.0292 meters.