enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rute (music) - Wikipedia

   en.wikipedia.org/wiki/Rute_(music)

   Commercially made rutes are usually made of a bundle of thin birch dowels or thin canes attached to a drum stick handle. These often have a movable band to adjust how tightly the dowels are bound toward the tip. A rute may also be made of a bundle of twigs attached to a drum stick handle.

3. Octophone - Wikipedia

   en.wikipedia.org/wiki/Octophone

   [3] [4] Owners of octophones have said that the instrument is made with birch neck, neck block, sides and back and a top made of spruce. [3] [5] [6] The neck is attached to the body with a 3/4 inch wooden dowel stuck into a hole in the neck block, rather than a strong joint such as the dovetail used on some guitars and mandolins. The ...

4. Dowel - Wikipedia

   en.wikipedia.org/wiki/Dowel

   A dowel plate. The traditional tool for making dowels is a dowel plate, an iron (or better, hardened tool steel) plate with a hole having the size of the desired dowel.To make a dowel, a piece of wood is split or whittled to a size slightly bigger than desired and then driven through the hole in the dowel plate.

5. Easy DIY Thanksgiving Centerpieces for a Picture-Perfect Table

   www.aol.com/lifestyle/easy-diy-thanksgiving...

   If your frog doesn’t have tines, fashion a holder by wrapping craft wire around a 3/4-inch dowel a few times, leaving a 1- to 2-inch tail that you insert into a hole of the flower frog.

6. Treenail - Wikipedia

   en.wikipedia.org/wiki/Treenail

   The mortise is drilled 1 ⁄ 16 inch (1.6 mm) smaller than the treenail to create a tight fit and take advantage of friction in the mortise. In cases where the treenail is 24 inches (61 cm) or longer, the treenail should be shaped 1 ⁄ 8 inch (3.2 mm) smaller than the other half. In the same case the mortise is drilled in two parts, with a ...

7. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.