Search results
Results from the WOW.Com Content Network
A regenerative receiver, by contrast, could often provide adequate reception with the use of only one tube. In the 1930s the regenerative receiver was replaced by the superheterodyne circuit in commercial receivers due to the superheterodyne's superior performance and the falling cost of tubes.
In 1914 Edwin Armstrong described the audion receiver. [1] In 1915 he described some regenerative audion receivers. [2] Fig.3 shows the audion, Fig. 8 the tickler coil regenerative audion and Fig. 9 the Miller effect regenerative audion. All circuits use one tube for RF amplification, RF demodulation and audio amplification.
Classical regenerative receiver using a single triode vacuum tube. The orientation of the "tickler" coil was carefully adjusted by the operator in order to vary the amount of positive feedback. The regenerative receiver also had its heyday at the time where adding an active element (vacuum tube) was considered costly. In order to increase the ...
In electronics, a Q multiplier is a circuit added to a radio receiver to improve its selectivity and sensitivity. It is a regenerative amplifier adjusted to provide positive feedback within the receiver. This has the effect of narrowing the receiver's bandwidth, as if the Q factor of its tuned circuits had been
A tuned radio frequency receiver (or TRF receiver) is a type of radio receiver that is composed of one or more tuned radio frequency (RF) amplifier stages followed by a detector (demodulator) circuit to extract the audio signal and usually an audio frequency amplifier. This type of receiver was popular in the 1920s.
Pages in category "Receiver (radio)" The following 27 pages are in this category, out of 27 total. ... Reflex receiver; Regenerative circuit; Roofing filter; S.
English: Block diagram of a regenerative radio receiver, a type of radio receiver widely used before World War 2. It consists of a tuned circuit that serves as a bandpass filter to select the desired radio signal out of all the signals picked up by the antenna, and a combined amplifier-detector to increase the power of the signal and extract the audio modulation (sound) signal from from the ...
Crystal radio used as a backup receiver on a World War II Liberty ship. While it never regained the popularity and general use that it enjoyed at its beginnings, the crystal radio circuit is still used. The Boy Scouts have kept the construction of a radio set in their program since the 1920s. A large number of prefabricated novelty items and ...