enow.com Web Search

  1. Ad

    related to: solderless connector sizes chart explained pdf file

Search results

  1. Results from the WOW.Com Content Network
  2. JST connector - Wikipedia

    en.wikipedia.org/wiki/JST_connector

    It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

  3. Crimp (joining) - Wikipedia

    en.wikipedia.org/wiki/Crimp_(joining)

    An electrical crimp is a type of solderless electrical connection which uses physical pressure to join the contacts. Crimp connectors are typically used to terminate stranded wire. [4] Stripped wire is inserted through the correctly sized opening of the connector, and a crimper is used to tightly squeeze the opening against the wire.

  4. Coaxial power connector - Wikipedia

    en.wikipedia.org/wiki/Coaxial_power_connector

    There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...

  5. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    Twist-on wire connectors are commonly color-coded to indicate the connector size and, hence, their capacity. They are commonly used as an alternative to terminal blocks or soldering of conductors, since they are quicker to install and, unlike soldered or crimped connections, allow easy subsequent removal for future modifications.

  6. IEC 60309 - Wikipedia

    en.wikipedia.org/wiki/IEC_60309

    The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

  7. Breadboard - Wikipedia

    en.wikipedia.org/wiki/Breadboard

    The adapter is then plugged into the breadboard via the 0.1 in (2.54 mm) connectors. However, the need to solder the components onto the adapter negates some of the advantage of using a solderless breadboard. Very complex circuits can become unmanageable on a solderless breadboard due to the large amount of wiring required.

  8. IEC metric screw sized connectors - Wikipedia

    en.wikipedia.org/wiki/IEC_metric_screw_sized...

    IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.

  9. SMB connector - Wikipedia

    en.wikipedia.org/wiki/SMB_connector

    SMB connectors are smaller than SMA connectors. They feature a snap-on coupling and are available in either 50 Ω or 75 Ω impedance. They offer excellent electrical performance from DC to 4 GHz. An SMB jack has a male center pin, while an SMB plug has a female basket. [1] [2] Connectors are available for two SMB cable sizes:

  1. Ad

    related to: solderless connector sizes chart explained pdf file