Search results
Results from the WOW.Com Content Network
A metal damp proof course (DPC) between the stone foundation and brick wall. Damp proofing in construction is a type of moisture control applied to building walls and floors to prevent moisture from passing into the interior spaces. Dampness problems are among the most frequent problems encountered in residences.
Spalling is a condition where constant high humidity or moisture breaks down masonry surfaces, causing deterioration and shedding of the concrete surfaces. Other coatings can be effective where condensation is the main source of wetness. It is also effective if the problem has minor dampness. Usually, interior waterproofing will not stop major ...
Structural dampness is the presence of unwanted moisture in the structure of a building, either the result of intrusion from outside or condensation from within the structure. A high proportion of damp problems in buildings are caused by ambient climate dependent factors of condensation and rain penetration. [1]
For premium support please call: 800-290-4726 more ways to reach us
Damp proofing: This is waterproofing used where the water table is lower than the structure and there is good free-draining fill. The membrane deals with the shedding of water and the ingress of water vapor only, with no hydrostatic pressure. Generally, this incorporates a damp proof membrane (DPM) to the walls with a polythene DPM under the ...
After the labor is completed, water damage equipment including air movers, air scrubbers, dehumidifiers, wood floor drying systems, and sub-floor drying equipment is left in the residence. The goal of the drying process is to stabilize the moisture content of impacted materials below 15%, the generally accepted threshold for microbial ...
Interstitial condensation is a type of condensation that may occur within an enclosed wall, roof or floor cavity structure, which can create dampening.. When moisture-laden air at dew point temperature penetrates inside a cavity of the structure, it condenses into liquid water on that surface.
But traditionally two-dimensional seepage problems were solved using a graphical procedure known as flownet. [ 3 ] [ 15 ] [ 16 ] One set of lines in the flownet are in the direction of the water flow (flow lines), and the other set of lines are in the direction of constant total head (equipotential lines).