enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Constant-voltage speaker system - Wikipedia

   en.wikipedia.org/wiki/Constant-voltage_speaker...

   The voltage is stepped down at the destination. Similarly, in a constant-voltage speaker system, the amplifier uses a transformer to step up the voltage of the audio signal to reduce power loss over the speaker cable, allowing more power to be transmitted over a given wire diameter.

3. Wiring diagram - Wikipedia

   en.wikipedia.org/wiki/Wiring_diagram

   An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...

4. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board.The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.

5. Speakon connector - Wikipedia

   en.wikipedia.org/wiki/Speakon_connector

   Speakon panel connectors (center) provided on a professional PA power amplifier by QSC with a power output of 2 x 700 Watt (4 Ohm) The Speakon (stylized speakON ) is a trademarked name for an electrical connector , [ 2 ] originally manufactured by Neutrik , mostly used in professional audio systems for connecting loudspeakers to amplifiers .

6. Electronic symbol - Wikipedia

   en.wikipedia.org/wiki/Electronic_symbol

   Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...

7. Impedance matching - Wikipedia

   en.wikipedia.org/wiki/Impedance_matching

   Typical push–pull audio tube power amplifier, matched to loudspeaker with an impedance-matching transformer. Audio amplifiers typically do not match impedances, but provide an output impedance that is lower than the load impedance (such as < 0.1 ohm in typical semiconductor amplifiers), for improved speaker damping.

8. Cable harness - Wikipedia

   en.wikipedia.org/wiki/Cable_harness

   A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]

9. Bridged and paralleled amplifiers - Wikipedia

   en.wikipedia.org/wiki/Bridged_and_paralleled...

   A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...