Search results
Results from the WOW.Com Content Network
On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk). The Windows Server version of CHKDSK is RAID -aware and can fully recover data in bad sectors of a disk in a RAID-1 or RAID-5 array if other disks in the set are intact.
CHKDSK verifies a storage volume (for example, a hard disk, disk partition or floppy disk) for file system integrity. The command has the ability to fix errors on a volume and recover information from defective disk sectors of a volume. The command is available in MS-DOS versions 1 and later. [1]
It included a more user-friendly interface than CHKDSK, more configuration options, [2] [3] and the ability to detect and (if possible) recover from physical errors on the disk. This replaced and improved upon the limited ability offered by the MS-DOS recover utility. [4] Unlike CHKDSK, ScanDisk would also repair crosslinked files. [5]
An Automated Optical Inspection device. Automated optical inspection (AOI) is an automated visual inspection of printed circuit board (PCB) (or LCD, transistor) manufacture where a camera autonomously scans the device under test for both catastrophic failure (e.g. missing component) and quality defects (e.g. fillet size or shape or component skew).
Dye penetrant inspection (DP), also called liquid penetrate inspection (LPI) or penetrant testing (PT), is a widely applied and low-cost inspection method used to check surface-breaking defects in all non-porous materials (metals, plastics, or ceramics).
Kept up-to-date by Procedure transmittals which are inserted Replaces and continues material formerly issued by Office of distribution as Director's memorandums, Deputy director's memorandums, Procurement memorandums, Invoicing memorandums, and General administrative instructions
In Windows NT used for CHKDSK flags (bits 7-2 always cleared, bit 1: disk I/O errors encountered, possible bad sectors, run surface scan on next boot, bit 0: volume is "dirty" and was not properly unmounted before shutdown, run CHKDSK on next boot). [30] Should be set to 0 by formatting tools.
Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]