Search results
Results from the WOW.Com Content Network
The equator is divided into 360 degrees of longitude, so each degree at the equator represents 111,319.5 metres (365,221 ft). As one moves away from the equator towards a pole, however, one degree of longitude is multiplied by the cosine of the latitude, decreasing the distance, approaching zero at the pole.
For example, a 10 cm (3.9 in) circular would have a maximum precision approximately equal to a 31.4 cm (12.4 in) ordinary slide rule. Circular slide rules also eliminate "off-scale" calculations, because the scales were designed to "wrap around"; they never have to be reoriented when results are near 1.0—the rule is always on scale.
degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a minute. Therefore, to convert from a degrees minutes seconds format to a decimal degrees format, one may use the formula
Common fractions are used most often when the denominator is relatively small. By mental calculation, it is easier to multiply 16 by 3/16 than to do the same calculation using the fraction's decimal equivalent (0.1875). And it is more accurate to multiply 15 by 1/3, for example, than it is to multiply 15 by any decimal approximation of one ...
Slices of approximately 1/8 of a pizza. A unit fraction is a positive fraction with one as its numerator, 1/ n.It is the multiplicative inverse (reciprocal) of the denominator of the fraction, which must be a positive natural number.
Four bags with three marbles per bag gives twelve marbles (4 × 3 = 12). Multiplication can also be thought of as scaling. Here, 2 is being multiplied by 3 using scaling, giving 6 as a result. Animation for the multiplication 2 × 3 = 6 4 × 5 = 20. The large rectangle is made up of 20 squares, each 1 unit by 1 unit.
However, when it is inconvenient to use base-60 for minutes and seconds, positions are frequently expressed as decimal fractional degrees to an equal amount of precision. Degrees given to three decimal places ( 1 / 1000 of a degree) have about 1 / 4 the precision of degrees-minutes-seconds ( 1 / 3600 of a degree) and ...
Because of the identity property of multiplication, multiplying any quantity (physical or not) by the dimensionless 1 does not change that quantity. [5] Once this and the conversion factor for seconds per hour have been multiplied by the original fraction to cancel out the units mile and hour, 10 miles per hour converts to 4.4704 metres per second.