Search results
Results from the WOW.Com Content Network
The High Speed Aerial looked for signals across a wide angle. RX12874, also known as the Passive Detection System (PDS) and by its nickname "Winkle", was a radar detector system used as part of the Royal Air Force's Linesman/Mediator radar network until the early 1980s.
Radar cross-section (RCS), denoted σ, also called radar signature, is a measure of how detectable an object is by radar. A larger RCS indicates that an object is more easily detected. [1] An object reflects a limited amount of radar energy back to the source. The factors that influence this include: [1] the material with which the target is made;
Sensors information (radar, sonar, and transponder data) is provided to the track algorithm using a polar coordinate system, and this is converted to cartesian coordinate system for the track algorithm. The polar to Cartesian conversion uses navigation data for sensors mounted on vehicles, which eliminates sensor position changes caused by ship ...
Ground targets further than this range cannot be detected, so the PRF can be quite high; a radar with a PRF of 7.5 kHz will return ambiguous echoes from targets at about 20 km, or over the horizon. If however, the PRF was doubled to 15 kHz, then the ambiguous range is reduced to 10 km and targets beyond this range would only appear on the ...
Doppler Radar Meteorological Observations Doppler Radar Theory. [full citation needed] Autocorrelation technique described on p.2-11; Real-Time Two-Dimensional Blood Flow Imaging Using an Autocorrelation Technique, by Chihiro Kasai, Koroku Namekawa, Akira Koyano, and Ryozo Omoto, IEEE Transactions on Sonics and Ultrasonics, Vol. SU-32, No.3 ...
In radar satellites, microwave signals are reflected off a persistent scatter in a target area, and their two-way travel time is measured by satellites. [1] Water vapor in the troposphere and free electrons in the ionosphere affect the propagation of microwave signals through the atmosphere because the different refractive index in these layers affects the speed of propagation.
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
Range and velocity can both be identified using medium PRF, but neither one can be identified directly. Medium PRF is from 3 kHz to 30 kHz, which corresponds with radar range from 5 km to 50 km. This is the ambiguous range, which is much smaller than the maximum range. Range ambiguity resolution is used to determine true range in medium PRF radar.