enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. 9mm Major - Wikipedia

    en.wikipedia.org/wiki/9mm_Major

    9mm Major is a wildcat cartridge of the 9mm Luger specifically for competition pistols designed to handle very high pressure. It is used in practical shooting competitions like International Practical Shooting Confederation (IPSC) and United States Practical Shooting Association (USPSA) to achieve a "Major" power factor, which earns more points for hits in specific zones on paper targets ...

  3. Cast bullet - Wikipedia

    en.wikipedia.org/wiki/Cast_bullet

    An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.

  4. 9 mm caliber - Wikipedia

    en.wikipedia.org/wiki/9_mm_caliber

    This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range.. Case length refers to the round case length.

  5. 9×19mm Parabellum - Wikipedia

    en.wikipedia.org/wiki/9×19mm_Parabellum

    The 9×19mm Parabellum (also known as 9mm Luger, 9mm NATO or simply 9mm) is a rimless, centerfire, tapered firearms cartridge. Originally designed by Austrian firearm designer Georg Luger in 1901, [ 6 ] it is widely considered the most popular handgun and submachine gun cartridge due to its low cost, adequate stopping power and extensive ...

  6. States with the Highest and Lowest Property Tax Rates - AOL

    www.aol.com/states-highest-lowest-property-tax...

    9. Kansas. When it comes to expensive states for homeowners, the state of Kansas doesn’t often come to mind. But it has an average property tax rate of 1.26%.

  7. Compression molding - Wikipedia

    en.wikipedia.org/wiki/Compression_molding

    Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

  8. 9×23mm Largo - Wikipedia

    en.wikipedia.org/wiki/9×23mm_Largo

    The 9mm Largo and the 9×23mm Steyr have almost identical dimensions, but they can be distinguished by the gilded jacketed bullet on the former, and the Austrian headstamp on the latter. [ 6 ] While external dimensions are almost identical, the 9×23mm Largo is a very different cartridge from the modern, high-performance 9×23mm Winchester .

  9. Semiwadcutter - Wikipedia

    en.wikipedia.org/wiki/Semiwadcutter

    Drawings of various types of semiwadcutter bullets 4-cavity Keith semiwadcutter bullet mold, the Lyman 358429. The semiwadcutter design consists of a roughly conical shape with the tip truncated flat (called a meplat), sitting on a cylinder (A at right). The base of the cone is slightly smaller in diameter than the cylinder, leaving a sharp ...