Search results
Results from the WOW.Com Content Network
A long list of noise measures have been defined to measure noise in signal processing: in absolute terms, relative to some standard noise level, or relative to the desired signal level. They include: Dynamic range, often defined by inherent noise level; Signal-to-noise ratio (SNR), ratio of noise power to signal power
The median filter is a non-linear digital filtering technique, often used to remove noise from an image, [1] signal, [2] and video. [3] Such noise reduction is a typical pre-processing step to improve the results of later processing (for example, edge detection on an image).
Array processing is a wide area of research in the field of signal processing that extends from the simplest form of 1 dimensional line arrays to 2 and 3 dimensional array geometries. Array structure can be defined as a set of sensors that are spatially separated, e.g. radio antenna and seismic arrays .
Noise reduction is the process of removing noise from a signal. Noise reduction techniques exist for audio and images. Noise reduction algorithms may distort the signal to some degree. Noise rejection is the ability of a circuit to isolate an undesired signal component from the desired signal component, as with common-mode rejection ratio.
This output can be converted to a signal by passing it through a digital-to-analog converter. There are problems with noise introduced by the conversions, but these can be controlled and limited for many useful filters. Due to the sampling involved, the input signal must be of limited frequency content or aliasing will occur.
The noise components are filtered out, but not quite completely; the signal components are retained, but not quite completely; and there is a transition zone which is partly accepted. In contrast, the signal subspace approach represents a sharp cut-off: an orthogonal component either lies within the signal subspace, in which case it is 100% ...
The recording of a heart beat (an ECG), may be corrupted by noise from the AC mains.The exact frequency of the power and its harmonics may vary from moment to moment.. One way to remove the noise is to filter the signal with a notch filter at the mains frequency and its vicinity, but this could excessively degrade the quality of the ECG since the heart beat would also likely have frequency ...
Adaptive noise cancelling is a signal processing technique that is highly effective in suppressing additive interference or noise corrupting a received target signal at the main or primary sensor in certain common situations where the interference is known and is accessible but unavoidable and where the target signal and the interference are unrelated, that is, uncorrelated [1] [2] [3].