Search results
Results from the WOW.Com Content Network
Waveform and phase sequence are fixed by the construction of the generator and its connections to the system. During installation of a generator, careful checks are made to ensure the generator terminals and all control wiring is correct so that the order of phases (phase sequence) matches the system.
for AC having a supply frequency of 50, 60 or 400Hz, though the use of other frequencies for special purposes is not excluded. This includes low-voltage installations, as found in most domestic and commercial properties, and extra-low-voltage systems, but excludes high voltage , as found in generation, transmission and distribution networks.
Transfer of energy between two circuits through the magnetic field that passes through both. inductive output tube A high power, high frequency amplifier tube, in some forms capable of megawatt pulses at hundreds of megahertz. inductor A circuit component with a concentrated inductance; a coil; stores energy in a magnetic field.
Electrical energy is distributed as alternating current because AC voltage may be increased or decreased with a transformer. This allows the power to be transmitted through power lines efficiently at high voltage, which reduces the energy lost as heat due to resistance of the wire, and transformed to a lower, safer voltage for use. Use of a ...
The spontaneous overall reaction can only occur if electrons move through an external wire between the electrodes. The electrical energy given off is the free energy lost by the chemical reaction system. As an example, a Daniell cell consists of a zinc anode (an electron collector) that is oxidized as it dissolves into a zinc sulfate solution.
Frequency control refers to the need to ensure that the grid frequency stays within a specific range of the nominal frequency. Mismatch between electricity generation and demand causes variations in frequency, so control services are required to bring the frequency back to its nominal value and ensure it does not vary out of range. [3]
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
Energy management is a new and upcoming topic in particular at the home. Older systems tended to be cable however all new systems use one of a variety of wireless solutions. This enables them to be effectively retrofitted into existing homes with the minimum of disruption.