Search results
Results from the WOW.Com Content Network
DFMA (also sometimes rendered as DfMA) is an acronym for design for manufacture and assembly.DFMA is the combination of two methodologies; design for manufacture, which means the design for ease of manufacture of the parts that will form a product, and design for assembly, which means the design of the product for ease of assembly deriving creative ideas at the same time.
The Walkman line was designed for "vertical assembly", in which parts are inserted in straight-down moves only. The Sony SMART assembly system, used to assemble Walkman-type products, is a robotic system for assembling small devices designed for vertical assembly. [citation needed] The IBM Proprinter used design for automated assembly (DFAA ...
Design for manufacturability (also sometimes known as design for manufacturing or DFM) is the general engineering practice of designing products in such a way that they are easy to manufacture. The concept exists in almost all engineering disciplines, but the implementation differs widely depending on the manufacturing technology.
Design for assembly addresses the combination of single parts or components to subassemblies, assemblies, modules, systems, etc., that are based on a differential design in mechanical engineering terms. An important issue is how the embodied interfaces within a product are designed (mechanical engineering, electrical engineering).
DFMA stands for design for manufacture and assembly. It is a practice for designing the engineering components keeping manufacturing and assembly aspects in mind. DFMA tries to tackle the problems that may come during the manufacturing and assembly at the design stage itself. Changes in the parts design to remove these problems while keeping ...
Design for verification (DfV) is a set of engineering guidelines to aid designers in ensuring right first time manufacturing and assembly of large-scale components.The guidelines were developed as a tool to inform and direct designers during early stage design phases to trade off estimated measurement uncertainty against tolerance, cost, assembly, measurability and product requirements.
The design for lean manufacturing equation is design for lean manufacturing success = strategic values minus the drivers of design and process wastes. A good design is one that simultaneously reduces waste and delivers value. [17] [18] There are multiple drivers that cause product, process, and lifecycle wastes. [19]
Similar to design for manufacture (DFM) and design for assembly (DFA) (which seek to avoid designs which are difficult to make), the concept of DFI considers measurement capabilities at an early stage in the product development life cycle and uses knowledge of the fundamental principles of metrology to achieve cost reduction. If the inspection ...