Search results
Results from the WOW.Com Content Network
An angle bracket or angle brace or angle cleat is an L-shaped fastener used to join two parts generally at a 90-degree angle. It is typically made of metal but it can also be made of wood or plastic. Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall.
A very common variant is an L-shaped shelf support, which is also called shelf bracket, and can be seen as a subset of angle brackets. There are also other forms of plug-in shelf supports commonly used in a wardrobes or cabinets (cabinet shelf support, wardrobe shelf support, shelf pin, shelf support peg, shelf support push).
Spacers can vary in size from microns to centimeters. They can be made of metal, plastic, glass, and other materials. Shapes include flat sheet, cylindrical and spherical. Two sizes of metal standoffs and one plastic standoff. The background depicts a standoff in use, holding a circuit board above a metal case.
Sealed cartridge bottom brackets are normally two pieces, a unit holding the spindle and bearings that screws into the bottom bracket shell from the drive side and a screw-in support cup (often made of light alloy or plastic) that supports the spindle and bearing assembly on the non-drive side.
What makes a bracket a bracket is that it is intermediate between the two and fixes the one to the other. Brackets vary widely in shape, but a prototypical bracket is the L-shaped metal piece that attaches a shelf (the smaller component) to a wall (the larger component): its vertical arm is fixed to one (usually large) element, and its ...
The plastic section modulus is used to calculate a cross-section's capacity to resist bending after yielding has occurred across the entire section. It is used for determining the plastic, or full moment, strength and is larger than the elastic section modulus, reflecting the section's strength beyond the elastic range.
In structural engineering, the plastic moment (M p) is a property of a structural section. It is defined as the moment at which the entire cross section has reached its yield stress . This is theoretically the maximum bending moment that the section can resist – when this point is reached a plastic hinge is formed and any load beyond this ...
Photovoltaic mounting systems (also called solar module racking) are used to fix solar panels on surfaces like roofs, building facades, or the ground. [1] These mounting systems generally enable retrofitting of solar panels on roofs or as part of the structure of the building (called BIPV ). [ 2 ]