Search results
Results from the WOW.Com Content Network
The Nadal formula assumes the wheel remains perpendicular to the rail—it does not take into account hunting oscillation of the wheelset, or the movement of the wheel flange contact point against the rail. [3] A variation of the Nadal formula, which does take these factors into consideration, is the Wagner formula.
Similar to the "Belgian tourniquet" in cycling, the "slingshot pass" is the most dramatic and widely noted maneuver associated with drafting. A trailing car (perhaps pushed by a line of drafting cars) uses the lead car's wake to pull up with maximum momentum at the end of a straightaway, enters a turn high, and turns down across the lead car's ...
A cylinder with longitudinal draft Profile view of a drafted cylinder with the draft dimension. In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid.
The ratios between the slip angles of the front and rear axles (a function of the slip angles of the front and rear tires respectively) will determine the vehicle's behavior in a given turn. If the ratio of front to rear slip angles is greater than 1:1, the vehicle will tend to understeer, while a ratio of less than 1:1 will produce oversteer. [2]
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).
Wheels can also lose traction when surface conditions reduce available traction such as on snow and ice. As an open differential delivers only enough torque to cause the "weakest" wheel to spin, if one drive wheel is stationary on a low traction surface (mud, ice, etc.), the deliverable torque is limited to the traction available on it.
The upper chuck lowers to make contact with the upper bead. The tire is inflated to the set point pressure. The load wheel advances to contact the tire and apply the set loading force. The spindle drive accelerates the tire to the test speed. Once speed, force, and pressure are stable, load cells measure the force exerted on the load wheel by ...
Modern cars do not use pure Ackermann steering, partly because it ignores important dynamic and compliant effects, but the principle is sound for low-speed maneuvers. Some racing cars use reverse Ackermann geometry to compensate for the large difference in slip angle between the inner and outer front tires while cornering at high speed. The use ...