Search results
Results from the WOW.Com Content Network
Helically coiled tube with secondary flow. The coil spring insert may enhance heat transfer without turbulence or additional heat transfer surface area. A secondary flow is induces the fluid creating two longitudinal vortices. This could result, (in contrast to a right tube) in highly non-uniform local around the periphery of the tube.
The Tubular Exchanger Manufacturers Association (also known as TEMA) is an association of fabricators of shell and tube type heat exchangers. [1] TEMA has established and maintains a set of construction standards for heat exchangers, known as the TEMA Standard. [ 2 ]
In shell-and-tube heat exchangers there is a potential for a tube to rupture and for high pressure (HP) fluid to enter and over-pressurise the low pressure (LP) side of the heat exchanger. [8] The usual configuration of exchangers is for the HP fluid to be in the tubes and for LP water, cooling or heating media to be on the shell side.
Tubular heat exchanger Partial view into inlet plenum of shell and tube heat exchanger of a refrigerant based chiller for providing air-conditioning to a building. A heat exchanger is a system used to transfer heat between a source and a working fluid. Heat exchangers are used in both cooling and heating processes. [1]
Location of Indonesia. Indonesia is a unitary sovereign state and transcontinental country located mainly in Southeast Asia with some territories in Oceania. Indonesia's economy is the world's 16th largest by nominal GDP and the 8th largest by GDP at PPP, the largest in Southeast Asia, and is considered an emerging market and newly industrialised country.
Shell and tube heat exchangers consist of a tube bundle which is placed inside the larger shell. [2] Due to this design these exchanger require twice the footprint of the plate heat exchanger in order to perform maintenance. Depending on the amount of cooling needed, shell and tube heat exchangers can be built in single or double pass ...
Baffles are an integral part of the shell and tube heat exchanger design. A baffle is designed to support tube bundles and direct the flow of fluids for maximum efficiency. Baffle design and tolerances for heat exchangers are discussed in the standards of the Tubular Exchanger Manufacturers Association (TEMA).
The number of transfer units (NTU) method is used to calculate the rate of heat transfer in heat exchangers (especially parallel flow, counter current, and cross-flow exchangers) when there is insufficient information to calculate the log mean temperature difference (LMTD). Alternatively, this method is useful for determining the expected heat ...