Search results
Results from the WOW.Com Content Network
Such plants can operate at 23–27 kWh/m 3 (appr. 90 MJ/m 3) of distilled water. [5] Because the colder salt water entering the process counterflows with the saline waste water/distilled water, relatively little heat energy leaves in the outflow—most of the heat is picked up by the colder saline water flowing toward the heater and the energy ...
The salt water collected at the bottom of each stage can be sprayed on the tubes in the next stage, since this water has a suitable temperature and pressure near or slightly above the operating temperature and pressure in the next stage. Some of this water will flash into steam as it is released into the next stage at lower pressure than the ...
Desalination is a process that removes mineral components from saline water. More generally, desalination is the removal of salts and minerals from a substance. [1] One example is soil desalination. This is important for agriculture. It is possible to desalinate saltwater, especially sea water, to
The VVC process is the more efficient distillation process available in the market today in terms of energy consumption and water recovery ratio. [1] As the system is electrically driven, it is considered a "clean" process, it is highly reliable and simple to operate and maintain.
The solar humidification–dehumidification method (HDH) is a thermal water desalination method. It is based on evaporation of sea water or brackish water and subsequent condensation of the generated humid air, mostly at ambient pressure. This process mimics the natural water cycle, but over a much shorter time frame.
In the U.S. state of Hawai'i, the Natural Energy Laboratory of Hawaii Authority tested an open-cycle OTEC plant with cogeneration of fresh water and electric energy, using a temperature difference of 20 °C (36 °F) between surface water and water at a depth of around 500 metres (1,600 ft). [citation needed]
Also, the effluent of existing sea water desalination plants can be treated further in a low temperature distillation to maximise the dewatering capacity of a desalination system. Low temperature distillation can accommodate variations in the plant load, running efficiently from 50 – 100% of plant design capacity depending on the available ...
The wall in the middle serves for receiving and evaporating sea-water into a hot air stream, and on the other side for condensing freshwater. The cooling from the evaporation helps water condense on the dividing wall, while the energy from the condensing vapor, now turned to droplets, passes back to the evaporation side, and is absorbed in the ...