Search results
Results from the WOW.Com Content Network
Any AR-15/AR-10 cartridge cases that are derived from the 7.62x51 can also be formed from these listed calibers. (7.62x51 & .308 are similar in external dimensions though the Brass has different internal capacity and Max PSI recommendations are different & Chambers are different.) AR-10 :The AR-10 is slightly larger and heavier than the AR-15 ...
The Canadian company Colt Canada (formerly Diemaco) licensed production of a rifle (Colt Model 715) and carbine (Colt Model 725), but later went on to produce an entire line of AR-15/M16 pattern weapons developed independently. In May 2005, Colt's Manufacturing Company acquired Diemaco, and the name was changed to Colt Canada.
The KS family of rifles was unveiled at military small arms conventions in 2022 as being developed for an international special operations forces (SOF) requirement. [2] In September 2023, the British Armed Forces selected the KS-1 rifle under Project Hunter to replace the L85A2-A3 and L119A1-A2 rifles used by the British Army Special Operations Brigade and elements of the Royal Marines ...
The standard AP-9 has a 5-inch barrel. The AP-9 Target began with a 12-inch barrel (Target AP-9), but this was later reduced to 11 inches (AP-9/11 Target); they both have a separate fore-end and a fluted barrel.
The AR Lower V5 is a 3D printed lower receiver for the AR-15 rifle. [1] It was created in March 2013 Defense Distributed printed using the Stratasys Dimension SST 3-D printer [1] [2] using the fused deposition modeling (FDM) method. [2] The receiver was able to handle enough stress to fire more than 600 rounds. [1]
The KG-9 and KG-99 have an open-end upper receiver tube where the bolt, recoil springs, and buffer plate are held in place by the plastic/polymer lower receiver frame. This design only allows for 115 grains (7.5 g) 9mm ammunition, and if a heavier grain ammunition or hot loads are used, the plastic lower receiver will fail or crack, rendering ...
9mm Luger.44 Magnum: This armor would protect against: 124 grain 9mm Luger Full Metal Jacketed Round Nose (FMJ RN) at a velocity of 1470 ft/s (448 m/s) 240 grain .44 Magnum Jacketed Hollow Point (JHP) at a velocity of 1430 ft/s (436 m/s). This is roughly equivalent to the obsolete NIJ Level IIIA ballistic protection level. [10] NIJ RF1 7.62× ...
The upper and lower receivers of the FGC-9 are fully 3D-printed, as are its pistol grip and stock. Its magazine, based on the Glock magazine design, may also be printed. For the MkI, an AR-15 or modified airsoft trigger system is needed for the fire control. In the MkII release, the developers released a package to 3D-print the AR-15 trigger.