Search results
Results from the WOW.Com Content Network
A specialty example of a climbing crane was introduced by Lagerwey Wind and Enercon [This paragraph needs citation(s)] to construct a wind turbine tower, where instead of erecting a large crane a smaller climbing crane can raise itself with the structure's construction, lift the generator housing to its top, add the rotor blades, then climb down.
The concept of a crawler crane undercarriage was first developed by the Bucyrus Company of South Milwaukee, Wisconsin in 1911. The first model, a Bucyrus gasoline-engine powered 'Type 14' dragline (usable with crane hook) had a standard 18.3m (60ft) lattice boom, a 4.27m (14ft) diameter swing ring and the crawler version weighed 47t (52USt).
The XGC88000 crawler crane, unlike the majority of crawler cranes, comes in two sections. The primary section consists of the crane itself, which boasts a maximum boom length of 144 meters, a maximum total length of 173 meters (including the counterweight radius), a maximum height (when fully erect) of 108 meters, a lifting capacity ranging between 3,600 and 4,000 tons [10] [11] [12] (although ...
Side-view of Super-PostPanamax portainer crane at the APM Terminal in the Port of Rotterdam. A gantry crane is a crane built atop a gantry, which is a structure used to straddle an object or workspace. They can range from enormous "full" gantry cranes, capable of lifting some of the heaviest loads in the world, to small shop cranes, used for ...
A special type of crane, suitable for constructing such tall buildings, that used hydraulics to lift components and provided its own power was used in construction of the World Trade Center. The Favco Standard 2700 Crane, manufactured by Favelle Mort Ltd. of New South Wales, Australia was informally called a "kangaroo crane." [160]
An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap. A hoist, the lifting component of a crane, travels along the bridge.
This culminated in the 1954 flagship model LS-98 crane and crane-excavator, one of the most successful pieces of construction equipment ever built. Production of this model continued for over 42 years (1954 to 1996) with over 7,000 units being shipped.
A block-setting crane is a form of crane. They were used for installing the large stone blocks used to build breakwaters, moles and stone piers. The mid-Victorian age was a time of great expansion in industry and shipping. Better protected harbours were needed, with man-made breakwaters extending beyond natural bays or coasts, in order to ...