Search results
Results from the WOW.Com Content Network
The converse is pound per square inch gauge (psig), indicating that the pressure is relative to atmospheric pressure. For example, a bicycle tire pumped up to 65 psig in a local atmospheric pressure at sea level (14.7 psi) will have a pressure of 79.7 psia (14.7 psi + 65 psi).
In scuba diving, bar is also the most widely used unit to express pressure, e.g. 200 bar being a full standard scuba tank, and depth increments of 10 metre of seawater being equivalent to 1 bar of pressure. Many engineers worldwide use the bar as a unit of pressure because, in much of their work, using pascals would involve using very large ...
A msw is defined as 0.1 bar (= 10,000 Pa), is not the same as a linear metre of depth. 33.066 fsw = 1 atm [citation needed] (1 atm = 101,325 Pa / 33.066 = 3,064.326 Pa). The pressure conversion from msw to fsw is different from the length conversion: 10 msw = 32.6336 fsw, while 10 m = 32.8083 ft. [citation needed]
A vacuum gauge is used to measure pressures lower than the ambient atmospheric pressure, which is set as the zero point, in negative values (for instance, −1 bar or −760 mmHg equals total vacuum). Most gauges measure pressure relative to atmospheric pressure as the zero point, so this form of reading is simply referred to as "gauge pressure".
10 kPa 1.5 psi Pressure increase per meter of a water column [26]: 10 kPa 1.5 psi Decrease in air pressure when going from Earth sea level to 1000 m elevation [citation needed]
One bar is 100 kPa or approximately ambient pressure at sea level. Ambient pressure may in other circumstances be measured in pounds per square inch (psi) or in standard atmospheres (atm). The ambient pressure at sea level is approximately one atmosphere, which is equal to 1.01325 bars (14.6959 psi), which is close enough for bar and atm to be ...
Convert mmHg to SI units as follows: 1 mmHg = 0.133 32 kPa. Hence the normal blood pressure in SI units is less than 16.0 kPa SBP and less than 10.7 kPa DBP. These values are similar to the pressure of water column of average human height; so pressure has to be measured on arm roughly at the level of the heart.
The US Navy Diving Manual gives conversion factors for "fw" (feet water) based on a fresh water density of 62.4 lb/ft 3 and for fsw based on a sea water density of 64.0 lb/ft 3. [1] One standard metre sea water equals: [1] 3.263 36 fsw; 102.018 cmH 2 O at 15 °C; 0.1 bar by definition; 10.0 kPa, in SI units; 100 000 Ba, in cgs units