Search results
Results from the WOW.Com Content Network
Figure 1: Example two-port network with symbol definitions. Notice the port condition is satisfied: the same current flows into each port as leaves that port.. In electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals to connect to external circuits.
A transducer may be a one-port as viewed by the electrical domain, but with the more generalised definition of port it is a two-port. For instance, a mechanical actuator has one port in the electrical domain and one port in the mechanical domain. [6] Transducers can be analysed as two-port networks in the same way as electrical two-ports.
In telecommunications, a network-to-network interface (NNI) is an interface that specifies signaling and management functions between two networks.An NNI circuit can be used for interconnection of signalling (e.g., SS7), Internet Protocol (IP) (e.g., MPLS) or ATM networks.
For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed. If the same style of line was used in a WAN (wide area network) diagram, however, it may indicate a different type of connection.
Network topology is the arrangement of the elements (links, nodes, etc.) of a communication network. [1] [2] Network topology can be used to define or describe the arrangement of various types of telecommunication networks, including command and control radio networks, [3] industrial fieldbusses and computer networks.
These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.
A simple electric circuit made up of a voltage source and a resistor. Here, =, according to Ohm's law. An electrical network is an interconnection of electrical components (e.g., batteries, resistors, inductors, capacitors, switches, transistors) or a model of such an interconnection, consisting of electrical elements (e.g., voltage sources, current sources, resistances, inductances ...
NCP was a simplex protocol that utilized two port numbers, establishing two connections for two-way communications. An odd and an even port were reserved for each application layer application or protocol. The standardization of TCP and UDP reduced the need for the use of two simplex ports per application to one duplex port. [1]: 15