Search results
Results from the WOW.Com Content Network
A multicore cable is a type of electrical cable that combines multiple signals or power feeds into a single jacketed cable. [1] The term is normally only used in relation to a cable that has more cores than commonly encountered. [ 2 ]
Typical live use of a multicore (thick cable on stage) Multicores usually create a link between the stage and sound desk, or live room and control room.When used in sound reinforcement, the multicore cable runs from the stage box or microphone splitter to the front-of-house sound desk, where it connects to a mixing console. [2]
In stage lighting, [1] a multicable (otherwise known as multi-core cable or mult) is a type of heavy-duty electrical cable used in theaters to power lights. The basic construction involves a bundle of individual conductors surrounded by a single outer jacket. Whereas single cables only have three conductors, multicable has ten or more.
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The ground rods create a ground plane under the antenna which increases the gain. The ground rods may extend horizontally from the base, but in antennas fed by coaxial cable as shown here they are usually sloped downward to increase the radiation resistance of the antenna from the 36 ohms of a quarter wave monopole closer to 50 ohms, so the ...
Sony introduced this protocol to control reel-to-reel type C video tape recorders (VTR) as well as videocassette recorders (VCR). It uses an DE-9 D-Sub connector with 9 pins (hence the name), where bi-directional communication takes place over a four wire cable according to the RS-422 standard .
VR-3000B Portable VTR Improved version of VR-3000. Digital TBC was available as a plug-in accessory, and required no modifications to the basic unit. Improved batteries. [41] AVR-1 (1973) Very fast VTR, vacuum columns, vacuum capstan, air transport. NTSC/PAL switchable. Analog TBC. [42] [43] ACR-25 (1974) Cart VTR, with two AVR-1 type decks. [44]
Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...